Replace Rear Disc Brakes in a Ford Mustang

Replace Rear Disc Brakes in a Ford Mustang

Replace Rear Disc Brakes in a Ford Mustang : Multi-thousand tips to make your life easier.

Whenever you need to replace the rear disc brakes in a Ford Mustang, one thing to consider is the need for a special tool to adjust the piston. This tool is called the Rear Caliper Piston Adjuster 206-026. Unlike other Ford vehicles, this tool is necessary when replacing the rear disc brakes on a Mustang. You can purchase the Rear Caliper Piston Adjuster 206-026 at any Ford dealership. Go to the auto parts department and look for the item. Once you have all the materials needed and have read the following procedures, you are ready to replace the rear disc brakes in a Ford Mustang.

Here is the complete list of things you will need to replace the rear disc brakes: brake fluid, car jack, 2 outer rear disc brake pads, 2 inner rear disc brake pads, Rear Caliper Piston Adjuster 206-026, regular mechanic's wire, sealed container, 4 spring clips, and torque wrench.

• Siphon half of the brake fluid and dispose of it. From the master cylinder reservoir, siphon half of the brake fluid and contain it in an approved sealed container. Go to your local auto parts shop and bring the brake fluid with you to dispose of it properly.
• Raise the Ford Mustang. Use a car jack to raise the Ford Mustang off the ground. To take the wheels off, loosen the lug nuts first with the torque wrench.
• Disconnect the caliper. Disconnect the rear disc brake caliper and let it hang from the body of the vehicle with regular mechanic's wire. Remove the old spring clips. Afterward, remove the outer rear disc brake pads, followed by the inner rear disc brake pads.
• Adjust the piston with the Rear Caliper Piston Adjuster 206-026. Rotate the piston clockwise with the Rear Caliper Piston Adjuster 206-026 so the piston seats properly. Since the old spring clips, inner disc brake pads, and outer disc brake pads are already removed, replace them with the new items.
• Apply the specific torque. Guided by the alignment pin found on the brake pad, align the notch and the caliper piston. Mount the rear disc brake caliper. Apply a specific torque of 24 ft. lb. using the torque wrench.
• Lower the Ford Mustang. Once you have replaced the wheels in their proper location, lower the Ford Mustang to the ground. You can situate the new rear disc brake pads by quickly pumping the brake pedal. Fill the master cylinder reservoir with clean brake fluid.

With the rear disc brakes replaced, make sure everything is working properly. Take a short test drive to make sure the performance of the Ford Mustang, with the replacement of the rear disc brakes, is not compromised. If problems arise, do not hesitate to ask a professional for assistance.