Remove Windshield Molding

Remove Windshield Molding

Remove Windshield Molding : Multi-thousand tips to make your life easier.

Windshield moldings hold your windshield in place. They have been introduced in new designs by car makers worldwide. The windshield is a unique glass design made especially for cars and other automobiles. Previously, windshields were made of ordinary glass. But because glass breaks easily and causes serious injuries during crashes, new designs evolved. Toughened glass was used to replace ordinary glass, but the safety problem was still not resolved. Finally, this was solved with laminated glass, which has two layers of glass with an inner cellulose layer. This layer holds the glass together when it is fractured, preventing it from bursting out during a collision and keeping it in place.
Auto crashes can break or crack your windshield depending on the strength of the impact on your car. Whether broken or cracked, it still poses a threat to the driver because it hinders visibility while driving and may spread over time. Therefore, you should replace your cracked or broken windshield immediately. But before you can remove your windshield, you should know how to remove the molding that holds your windshield to your car. Windshield molding holds the windshield and keeps it in place. Moldings are usually made of rubber, so the edges of the windshield do not cause cuts when you touch them. Moldings are also designed not only to hold the windshield in place but also to give your car a nice, neat-looking frame. Some cars are also installed with outer stainless molding for a classier look.

• You can always buy instruction manuals on how to remove windshield moldings. Most cars have the same molding installations. You can also search the Internet or seek help from professionals who deal with this kind of problem. But if you want to learn how to do it manually, here are some tips for removing windshield molding.
• First, you will need these tools for the procedure:
  • Automotive cutting knife
  • Flat tip screwdriver
  • Razor blade
• Then follow the steps below.
• Pry the plastic trim or rubber molding away from the windshield. Be careful when prying, because some moldings are tough to remove. Use your flat tip screwdriver to do this. Take your time.
• Cut down starting from the top and begin trimming the molding. Some cars have rubber molding inside and stainless trim molding outside. You just have to remove the outer lining first. Sometimes, the outer lining is just clipped onto the rubber, and the rubber is clipped onto the glass or frame. You can buy tools that are made to remove these clips properly. Removing the molding will take time, so be careful with every inch.
• Using your razor blade, remove residual moldings from your car. Take time with this step as well, because the rubber molding can be tough too. Be careful, because you might scratch your car when doing this step. You might peel off your car’s paint with the razor blade.

After the molding has been removed, you can now replace your windshield as instructed in your manual. Read the instructions first before placing your windshield to avoid misplacing it.