How to Replace a Standard Car Radio Antenna

How to Replace a Standard Car Radio Antenna

How to Replace a Standard Car Radio Antenna : Multi-thousand tips to make your life easier.

Traveling can be stressful even if you have your own car. The stress is intense if there is heavy traffic and you are in a hurry. Listening to music is one effective way to combat boredom and stress when you are traveling in your car. If you forgot your tapes, CDs, or flash drive containing your MP3s, then listen to the radio. If your car radio does not have an antenna, or if it is busted, then the guide below will help you replace a standard car radio antenna:

• Remove the car's existing antenna. Determine the location of the antenna opening by inspecting it or by looking at the manual. Use needle-nose pliers or a wrench to remove the antenna. This will loosen the nut on the base of the antenna mast, which houses the antenna. Remove the antenna mast. Open the underside of the antenna mast to locate the antenna. Pull out the car radio's antenna coaxial cable. It is the solid wire that connects the car's interior to the antenna.
• Unplug the antenna coaxial cable. Unplug it from the car's extension coaxial cable. This is a cable that connects the car radio to the antenna. If there is a short distance from the radio to the antenna mount, then there might be no extension coaxial cable. If that is the case, unplug the coaxial cable from the antenna lead that can be found at the back of the radio. Remove the coaxial cable. Take note of the route that the cable follows so you can install the new cable easily.
• Read the new antenna's manual. Every quality antenna has a manual. If you have bought a pre-owned or lower-quality antenna, ask an experienced car technician or owner for know-how. You can also read DIY books or visit websites to get information.
• Inspect the car's fender area. There must be no rust where the antenna mast will be mounted. So clean the fender area before installing the new antenna.
• Plug in the car stereo's new coaxial cable. Plug it into your car's extension coaxial cable. Some Ford and General Motors cars will require an adapter so the two cables of your car stereo can be connected together. You can buy these cables at your local car audio stores at a cheaper price.
• Route the new antenna cable along the old antenna cable route. Plug the cable into the antenna lead if the stereo does not have an extension coaxial cable. Tape or tie the string that you will put onto the extension cable. This will bind the new coaxial cable and guide it to the fender's antenna mount.
• Insert the antenna mast into the fender hole. Screw the mast tightly into the coaxial cable. Also, reposition the retainer nut on the antenna mast's base. Securely tighten the retainer nut. Reposition the stereo's cover panel to finish the job.

Try the new standard radio antenna in your car. See if it works effectively. Try to pick up as many stations as it can. Refer to the antenna's manual if you experience problems. This will also help you check the replacement process.