How to make a heater 1998 E36 replace

How to make a heater 1998 E36 replace

1998 BMW E36 is part of the third Generation of the long-running 3-series. Blower motor for heating and air conditioning is blowing warm or cool air into the Interior. If this fan fails, the rules of the occupants of the BMW, the temperature of the interior. If the blower starts to make a high-pitched squeal, it may be to failure. Replace the blower motor is a relatively tedious and time-consuming work, but not impossible for the Amateur mechanic.

What you Need

• 
  
  
• 
  ratchet and socket set
  
• 
  Small ratchet
  
• 
  3-inch socket extension
  
• 
  cable tie or length of wire (optional)
  
  • 
    pliers
    
  • 
    Phillips screwdriver
    
  • 
    flat screwdriver
    
  • 
    adjustable wrench
    
  • 
    wire cutter
    
    
    • Close the recirculation air doors on the climate, with climate control buttons. You leave the key in the ignition to the second position, then disconnect the battery cable goes to the negative terminal of the battery. the
    • make Sure that the wiper blades in the correct resting position (when not in use), and mark the spot on the windshield with a piece of tape. Pry off the caps on the wiper arms with a screwdriver. Remove the 13 mm nuts from below with the socket and ratchet. Take off both windshield wiper arms. the
    • Open the hood. Remove the black engine cover under the windshield wiper by putting it up gently to free it from the vehicle. Pry out the plug on the fuel rail cover and engine cover, then remove the screws and nuts holding the covers in place. Remove the insulation on the top side of the device to the DME cover the three upper clips pry off with a flat screwdriver. Remove the two 10 mm nuts on the bottom. Remove the four screws that hold the DME cover in place and remove the cover. the
    • Remove the two screws in the top center of the hood with a Phillips screwdriver. Unplug the wiring harness to the Motor and out of the way. In order to keep it out of the way, tie it with a cable tie or length of wire. the
    • Remove the 7 mm screws from the hood. Set aside the dome. Remove the three 10 mm that hold the wiper motor in place. Remove the large nut that holds the left-hand wiper shaft in place with an adjustable wrench. Remove the 10-mm nut that attaches the support to the bottom piece into place. Remove the 10 mm nut that holds the support to the wiper Assembly. the
    • Remove the front cover on the air box, the one with three clips. Turn the twist lock in the center of the cover. Hold the bottom of the cover and swing it up to release it. the
    • Remove the left side of the airbox by removing the two clips on the top and bottom. The blower is visible. Disconnect the wires from the blower motor by gently pulling off with a pliers. the
    • Remove the clip holding the engine in Position, drag it with any kind of tool that can be connected to the clip, so that it can be demolished. You cut the plastic squirrel cage on the blower motor with a wire cutter and set aside the cage. Pull the blower motor and the remaining part of the squirrel-cage. the
    • Install the new blower motor and squirrel-cage, in the reverse manner that the old was removed. Make sure that the electrical connections are to the outside, so that they can be re-connected. Install the new motor and squirrel cage to take some of the manoeuvres and fishing to seat properly in the Airbox. You connect everything in the reverse order. If you have got so far, as a reference to the wiring of the new fan-motor, connect the battery and turn on the air conditioning, to ensure that the new blower motor is in operation.